               CML RELEASE NOTES
V01.01 05-2-2019
-----------------
- Prochot configuration change for CML S, gpio converted to push pull ( due to board missing pull up, OD buffer implemented in board)

V01.00 01-16-2019
-----------------
- CML S PO changes added
- Ported ICL changes for PMAX framework. 
- Ported support for UVTH command from ICL. 
- Support for new battery parameters: CMPP, RBHF, VBNL.
- Charger configuration support for CML. Type C charging support yet to be added.
- EC to write Battery MinSysVoltage, SysResistance values.
- Fix for OOBs in MAF mode.
- Detect MAF / SAF mode upon G3 exit. 
- Add PD library into CML with support for TI PD 988 
- Create TIPDCommon to handle PD common functions
- Perform PD initialization based on PD HW revision 
- Enable USB-C dead battery scenario 
- USB-C charging now uses current from PD contract

V00.02 1-15-2019
-----------------
- Support added for CML LP4 ERB Board id 
- Updated battery charger setting for AC Adaptor

V01.00 11-22-2018
-----------------
- Support added for CML Board id in WHL/CFL S & H Code Base


NOTES:
=====
Required Hardware:
	CML Board
	Dediprog to program KSC binary image.

Flash Programming:
	1) Power off the board completely and disconnect all the power sources.
	2) Connect the Dediprog SF600 to EC Programming header
	3) Open the Dediprog software and select the chip "W25Q128FV"
	4) Select the 16MB integrated image (output of FIT tool - IFWI )
	5) Click on Batch to perform erase/program/verify (Make sure the programming starts from offset 0)
	6) After programming disconnect dediprog and apply the power.
